Tri State Hydraulics



Series LH Low Pressure

500-1500 P.S.I. Hydraulic Service

 

PRESSURE RATINGS

Series "LH" Hydraulic cylinders are rated for use at operating pressure levels that vary with bore size, rod diameter, mounting style, and stroke length. The maximum recommended operating pressure for Flange mount Models "C" and "D" are given on pages showing dimensional information for these mounting styles. Refer to data on "Piston Rod Size Selection" given on page 7 for effects of stroke length on Maximum Recommended Operating Pressure.

INDUSTRY STANDARD MOUNTING DIMENSIONS

LYNAIR Series "LH" models conform to ANSI Standard B93.15-1971 for Mounting Dimensions of Square Head Industrial Fluid Power Cylinders and meet or exceed JIC Hydraulic Standards.

CYLINDER PORTS

N.P.T.F. ports are standard and provided unless otherwise requested. S.A.E. "O"-Ring style ports are optional and may be specified at no additional cost. Standard sizes are shown below.

GENERAL CONSTRUCTION INFORMATION

Series "LH" Hydraulic models are made with the same quality features as Series "A" Air cylinders detailed on the preceding page. The two types of cylinders share common exterior and mounting dimensions with the only construction variations being in the rod seal set as noted.

EXTERIOR MATERIALS

Front and Rear Heads are accurately machined from precision square steel blocks. Cylinder Tubes, Bearing Retainers, and mountings are constructed of steel for maximum strength and durability.

ROD SEALS WITH SPRING EXPANDER

Pressure energized multiple lip packing set consists of three Buna-N V-rings supported by a bronze male adapter which aids seal expansion in response to system pressure. A wave spring exerts sufficient preloading to prevent weeping when system pressure is off.

ADJUSTABLE CUSHION OPTION

Cushions are optional at either one or both ends of the cylinder. When provided, close fitting surfaces of mating components trap air which decelerates the piston speed before reaching the end of stroke position. Flush fitting Cushion Screw permits adjustment in deceleration rate while interchangeable Ball Check aids start up upon reversal of travel direction.


HYDRAULIC & AIR CYLINDERS LYNAIR INC. NFPA Tie Rod Cylinders Series LH Low Pressure